If the projector cannot be turned on and the WARNING TEMP indicator lights red, unplug the AC power cord and contact service.įinally, the POWER indicator which is at the bottom right of the group of indicators would blink after the lamp has turned off but the fans would still be running during a critical cool-down period where the AC must not be disconnected until the indicator stops blinking (is steady). In this case, unplug the AC power cord and plug it, and then turn on the projector once again to verify operation. When the projector detects an abnormal condition, it will be automatically shut down to protect the inside of the projector and the WARNING TEMP. However, if the WARNING TEMP lights red (steady) then an abnormal condition has been detected. Is the filter clean? Clean the filter periodically or replace it with a new one. Move the installation of the projector away from the duct or vent. Has the projector been installed near an Air-Conditioning/Heating Duct or Vent? Did you provide appropriate space for the projector to be ventilated?Ĭheck the installing condition to see if the air vents of the projector are not blocked.
#Sanyo pro xtrax multiverse projector plc xt35l manual
In an over-temperature condition the manual states that the following should be done. This projector has many useful functions such as lens shifting, ceiling and rear projection, perpendicular omnidirectional projection, variety of lens options. Owner's Manual page 69 shows WARNING TEMP indicator at the top left which would be blinking on an over-temperature shut-down. Suspect shut down due to an over-temperature condition.
0 kommentar(er)
